Waterproofing

and Coatings

RHENACRET LINE PRODUCTS

Rhenagyp

It is a textured aqueous dispersion, formulated based on elastomeric acrylic emulsions, which is used as an adhesion promoter on structures that are going to be covered with plaster, cement stucco or ceramic adhesives, eliminating pointing, chemical stripping, the use of surface setting inhibitors or other procedures used to generate roughness and improve the adhesion profile of the surface to be coated.

Rhenacret Flexo Seal

It is a waterproof and flexible two-component cementitious membrane designed to be applied to both interior and exterior surfaces where waterproofing is required on the positive or negative side.

It can be applied with a brush, spreadable with a trowel or projected at low pressure.

 

It consists of a Part A, liquid consisting of a polymeric dispersion in aqueous solution.

 

Part B consists of a cementitious pre-dosed mortar

with aggregates and special additives.

 

Rhenacret TOP RTU

It is an elastomeric additive that added to mortars and plaster mixes improves adhesion and workability.

It acts as a water reducer, increasing resistance, providing flexibility and impermeability.

Rhenacret Red Coat

It is a water-based, moisture-resistant, purplish-red textured primer with a semi-gloss finish.

It has such a viscosity and rheology that it exhibits good fluidity on application and outstanding leveling on drying. This allows easy handling, low waste and a very good surface finish once the film dries.

Rhenacret Promomour

It is a two-component cementitious mortar designed

as an adhesion bridge for the placement of plaster and stucco plaster on concrete walls, avoiding pointing.

It acts as a mechanical adhesion bridge that traps the plaster gel, uniting it to the wall under a strong anchorage.

 

Part A: Liquid component of an aqueous polymer dispersion.

 

Part B: Pre-dosed cementitious mixture of mineral fillers and additives.

All rights reserved, DEXIMA SpA, designed by Bigidea